Diesel ECU Tuning Course with WinOLS – Online Remap Training
Now playing: torque category ( torque request, cranking, limiter)
Log in to unlock this episode.
torque category ( torque request, cranking, limiter)
“Torque request table or driver wish map”
Torque-based management control is more complex. ECU usually sets the pedal position not as a request for injection but as a request for torque. ECU can manage the torque request when the driver presses the pedal. Torque-based engine management systems need to have different tables so that ECU can control the engine output torque model in all engine operating conditions. Torque-based electronic injection control calibration is the last step in engine calibration. This calibration for the car and engine is done on a load-holding dyno with an “open ECU” by engineers. To obtain the actual values of the injection with the amount of torque requested by the driver in steady-state conditions, it balances the amount of engine load relative to engine revolution and the amount of torque close to engine revolution and load.
torque during cranking
Starting
Starting an engine involves the following stages: cranking, ignition and running up to self-sustained operation. The hot,
compressed air produced by the compression stroke has to ignite the injected fuel (combustion start). The minimum ignition temperature required for diesel fuel is approx. 250 °C.
That temperature must be achievable with a sufficient degree of certainty at low engine speeds and in cold weather conditions with a cold engine. There are a number of physical parameters which tend to oppose that aim:
. The lower the engine speed, the lower is the ultimate pressure at the end of the compression stroke and accordingly, the ultimate temperature.
In order to prevent soot at the start time, a table in the ecu defined on the basis of engine speed and engine temperature adjusts the amount of fuel injected, as seen in the figure.
“Toque limiter map ”
In diesel engines, torque is controlled by fuel. The amount of fuel must be controlled in order to control the torque of the engine. As a result, a map is defined to control engine torque, which is controlled by engine speed and air pressure. See the picture for this table.
For more information and probable problems feel free to contact us:[email protected]
